However, it could take a few months or longer for the stump to.

Remove Old Stumps This stump killer is only going to work on tree stumps that have seasoned for months prior to treatment. Our product is conveniently ready to use when it arrives. Drill 4 holes into the stump and pour Stump Out into each hole. Fill these holes with water and let it sit for weeks/5. Line up a long copper nail at the base of the tree stump beginning on either side.

Hold the middle of the nail with your non-dominant hand and hammer down firmly on the head of the nail until it is halfway in. Jul 21, Use the end of a hammer or long tree removal fort erie ontario to pack the copper sulfate into the stump holes.

Her chapbook, Slap Leather, is forthcoming from dancing girl press.

Cover the holes with a plastic garbage can lid and then weigh the lid down with bricks or concrete blocks. Do not use a metal lid, as the copper sulfate will corrode the lid. Wait several weeks. The copper sulfate will not dissolve the tree stump.

Aug 17, Use a chain saw or bow saw to cut the stump down as close to the ground as you can, without allowing the chain saw's teeth to strike the ground (this will dull your chain). Wear steel-toed boots for this part of the job. Drill holes a few inches deep into the stump in numerous places, using the biggest, widest drill bit you have. Jun 12, If you do elect to try the copper nail option, make sure you drill pilot holes. Copper is a softer metal, and depending on the type of tree stump you have, you could end up bending the nail as you hammer it into the wood.

Using Epsom Salts. Using Epsom salt, also known as magnesium sulfate, is perhaps the most common way to naturally rot a tree stump. May 11, The following stump-killing/removal chemicals may differ in type, but each offers a reliable way to eliminate an unwanted stump.

Best Overall. Stump remover is generally purchased in powdered or liquid form. Some powders require you to mix them with water before application. To successfully rot the tree stump, you need to drill a few holes in the stump and pour the mixture in. Then you must wait a few. It's been said that taking down a tree is the easy part compared to removing the stump.

I hope to dispel that notion by employing what may be the easiest cos.