Special Offers On Accessories 6.
Aug 12, Cut across the bushing face into the rubber. Tap off the washer. Cut across the sleeve in places and then collapse it into the center with the chisel. Drive out the sleeve with the punch, use the chisel to drive the bushings up and out, same for the steel cup. Done. Installation requires the tool to compress and flare the new bushings in place. 2 days agoC7 Corvette, - C7 ZR1 Discussion; C7 General Discussion; C7 Tech/Performance; C7 Z06 Discussion; C7 Forced Induction/Nitrous; C7 Dealer Inventory; C7 Corvettes for Sale; C7 Parts for Sale/Wanted; C7 Vendor for Sale; C6 Corvette, - C6 Corvette ZR1 & Z06; C6 Corvette General Discussion; C6 Tech/Performance; C6 Scan & Tune.
Jul 29, This forum is for video's pertaining to Corvette's, Racing (Street/Strip), Interviews, and Off Topic. Side pipes for my by 73shark.
AM. Jan 13, Corvette Forums. C6 Corvette Forums. C6 Corvette General Discussion. On the rear, because they couldn't adjust down as far I cut one rib from each rear bolt bushing with a cable saw found in the plumbing section of Home Depot(5).
This lowered my car about an inch all the way around. The 'bushing' is the black bumper covering the end of the Estimated Reading Time: 1 min. Jul 03, I decided to cut the bushings on the stock bolts after reading on forums. this is a video of the process and outcome. I never had anyone to help film but if. T F [email protected] [email protected] West Coast Corvette W Business Center Drive Orange, CA Jul 29, This forum is for video's pertaining to Corvette's, Racing (Street/Strip), Interviews, and Off Topic.
Side pipes for my by 73shark. AM. Mar 28, C7torch red, Z51, 7 speed manual There is a sleeve in the linkage and once it was removed the bushing fit like butter. I first tried in myself and cut the hell and mashed the bushing up. The machine shop was no better.
The bushing diameter is bigger than the hole. Corvette Forum: bushleaning.bar Corvette Forums. Oct 21, The front bushing (lowering bolt head) is composed of alternating layers of rubber, and steel, each a little more than 1/8" thick. The"2/3" cut, as people refer to it, is really 3/4 removal where you cut off the 2 lowest steel plates and the rubber between.
This leaves you with the lowering bolt head, and 1/8" of rubber on top of it. Jan 02, Dec 24, #1. Ordered a Braille battery for my C7. I want to cut about lbs from the car. The battery at about 20lbs lighter then the stock. Changed to headers 15 lbs lighter then the stock manifolds and carbon air metric removable drill bushings 5lbs.
In the spring I'm thinking of going with Burns stainless 2 stage mufflers which should reduce the weight.