The rubber in the old can be squeezed between your.
Sep 25, Replacing the axle sway bar bushings on a Ford van/truck E, E or E Thanks for stopping by the Ozzstar channel! -GlenSway Bar Bushing Moog: htt. Climb under the Ford van's front end with your socket set. Remove the sway bar bracket mounting bolts with your socket set.
Lower the sway bar bracket from the chassis by hand. Remove the bushing from the bracket by hand. Oct 23, I disconnected the sway bar from the axle by removing four nuts, two on each.
side. Next. I removed the driver’s side end link by removing the bolt that goes through the. end link, spacer block, and frame. Next, on the passenger’s side, I removed the Estimated Reading Time: 3 mins. Dec 12, disconnect neg battery cable, disable air bag (if equipped, it was an option in 91), jack up vehicle, support w/ safety stands, remove front wheels, disconnect sway bar ends from the lower control arms, remove bolts retaining sway bar bushing bushleaning.bar sway bar.
Check bushings for splits and deformation, clean inner and outer surfaces of bushings before installation, Make sure bushings. May 31, Had to replace these bushings.
Drive the Ford van's front wheels onto the ramps.
The drivers side fell out but the passenger side seemed to be fused to the inside of the axle. I had to use a die grinder to g.
May 15, the popping noise is probably sway bar end links. they commonly wear out, cost is around 20 each side. easy to replace. jack up car, remove wheel, undo 2 bolts. install is reverse. its easy enough to narrow it down to the sway bar area. take off one link. then drive around, if the noise is gone, its definately part of the sway bar.