Nay Aug 3,

Mar 02, How to remove - install control arm bushings& anti roll sway bar eye bolt bushleaning.bar: Vw PoloModel: Mk4 6nPowerflex part no:PFFPFFTrack: Royksop Missing: cast iron. Mar 18, Spray PB Blaster all around the bushing interface and let sit for 30m or so. The heat will help the PB draw down into the fit between bushing and control arm.

Wipe up the excess PB. and try to push the bushing out. No luck. use the torch to apply serious heat while continuing to apply pressure. Jun 28, Removing plugs and bushings from cast iron radiators. Dave Stroman Member Posts: June in THE MAIN WALL. For less thaninvestment at Harbor Freight Tools I pick up a 1" socket set and a breaker bar. I pulled all the plugs and bushing out of 3 radiators without any chiseling. Had to use a cheater, but they all came out.

Jan 19, Removal: Pressing out the rear bushing using press was easy. Metal ring remained. Instead of using hack saw or chisel, tried all the fittings in press kit. Used closed end adapter and middle fitting of the fall tree line set. Turns out the adapter is the exact fit for the outer race and exact for the rear arm. Dec 20, To install the new bushings, get a short piece of cast iron pipe (called a nipple) that fits tightly over the exposed rubber on the flanged end of the new bushing.

Lightly sand the bushing socket in the control arm to remove any rust buildup and file out any hard burrs. Spray the control arm socket area with some WD40 or liquid wrench. Mar 16, I am planning to replace my upper control arm bushing, and was wondering how do you get it out.

I know there is a tool going for aboutHas anyone made their own tool, or are there other ways in removing also installing it. Thanks. Remove the lower strut mount bolt. Remove the lower control arm. 3. Press out the rubber bushing and shells from the inner and outer pivot ends. A hydraulic press will be needed. Clean and lubricate the inside of the control arms (where the shells were). Grease all sides of the bushing that contact metal.

4. Install the bushings. Aug 05, 3)Use a set up where there is a washer on the inside that is close to the O/D of the bushing and pull it through with a threaded rod into a small section of pipe that is larger than the O/d of the bushing.

Upper Control Arm Bushing Service Set SKU Used for Quick Bushing Removal / Installation Without Removing Control Arm from Vehicles The Complete Solution for Servicing Wheel Hubs and Bearings On the Vehicle Without Removal Use on Aluminum or Cast Iron Pinch Mounts; Includes 2 Dowel Sizes AZTool1. Tweet. When it comes to A Body suspension upgrades a necessity is a rear trailing arm bushing replacement.

Here we chose Prothane for our A Body suspension package due to the stiff nature of the polyurethane bushings to accent the touring aspects of the car. We also take a look at making a DIY tool for bushing installs using the old bushing.