For the second one you need to disassemble the trans further

Feb 14, Replace without Housing Removal; Easy How To Replace Automatic Transmission Extension Housing Tailshaft Bush Bushing & Seal; DIY Replace Automatic Transmis. Apr 30, place the tailshaft in a degree oven & the bushing in the freezerthe coefficient of thermal expansion is your friend.

Click to expand You could do this if it's a TH But there's no tail shaft housing on a R so you would have to put the whole transmission in the oven. Dec 11, It's just as easy to remove the tailshaft housing from the transmission and remove the bushing standing up, instead of laying under the car.

Last one I did, all I used was a screw driver and hammer to remove it, once it was out of the car. Come think of it, I don't see how either of those tools will fit into the tailhousing with the mainshaft in there too. May 04, T5 tailshaft bushing removal tool. Jump to Latest Follow 1 - 14 of 14 Posts. Michael Yount Registered. Joined Apr 10, 36, Posts. Discussion Starter #1 1 mo ago. About to tackle this on mine -- anyone got the tool for removing the bushing.

Made in the USA! Easy removal and installation of the extension housing bushing, without removing the extension housing. For use on these Transmissions: GM,R, GM Borg-Warner T5 (Tremtec T-5) (World-Class T-5) For removing bushings with a minimum ID of" and a maximum OD of". Maximum shaft diameter is"/5(12). Apr 04, Apr 3, #2. Joe, I don't think it needs a special tool, but you have to remove the tailshaft housing assembly knock the olds bushing out and install the new one.

We couldn't do it Sat (ran out of time) because it requires supporting the trans, removing the trans mount (and crossmember?) and removing the tailshaft housing. This is the tail shaft bushing located in the tail shaft of your transmission that supports your driveshaft yolk. This product will fit Mustangs running a T-5, AOD, AODE, C4, C5 and Ford 4 speed transmissions.

It is made from OE quality stamped steel and individually. Replaces Ford part number: B3TZ-7AB. -Fits Mustang with. May 15, Need to remove the tailshaft bushing on a Nash 4+1 trans without removing the trans from the car. Looking to buy/rent the bushing removal tool (Snap on # S). Anyone have any tailshaft bushing removal on getting this tool or any other way of removing the bushing.

Note this trans uses the large bushing.